Source <1|2>; Mode Sweep; Source <1|2>; Mode List; Frequency Setting Commands (Cw); Source <1|2>; <Frequency <F> <U - Valon 5009a Operation Manual

Source <1|2>; MODe SWEep
4.5.2
Sets the selected source to sweep mode. A STARt frequency, STOP frequency, STEP frequency,
sweep RATE will also have to be set.
Source <1|2>; MODe LIST
4.5.3
Sets the selected source to the list mode. When set to list, the synthesizer frequency is set to
preset values much like radio push-buttons. The specific list value from the list is selected by the
hardware bit selected by the user port.

4.6 Frequency Setting Commands (CW)

The frequency setting commands are listed below.
Source <1|2>; <Frequency <F> <U>
4.6.1
Source; Frequency is the method for setting the single tone frequency. The range of <F> is
23.5MHz to 6000MHz but can be expressed as Hz or GHz.
Follow the Source or just s command with either a 1 or 2 to select Source 1 or Source 2. If no
source number is specified then the command will be set to source shown at the cursor.
Source 1; Frequency 2115 M; Sets source 1 to 2115MHz. Since no source number was specified
the default source is 1.
f 2115; Defaults to the present source and sets the frequency to 2115MHz without specifying
the units.
f 2115m also sets the present source to 2115MHz by default since no source was specified.
s 2; f 2445 is a method for setting source 2 to 2445MHz.
Source 2; Frequency 2000M sets source 2 to 2000MHz
Source 2; Frequency; CW 2000M sets source 2 to 2000MHz
Source 2; Frequency 2000000000 sets source 2 to 2000MHz
S 2; f 2000000k sets source 2 to 2000MHz
Various valid query forms are accepted
For example: Frequency? returns the frequency for the currently selected source.
Valon Technology 5009a Operations Manual – Version 1.38 Page 26