Configuration Manager Sweep Page - Valon 5009a Operation Manual

3.3 Configuration Manager Sweep Page

Controls for operating sweep mode are found on this page. Sweep is implemented by stepping
from the Start Frequency to the Stop Frequency by an incremental Step Frequency at the sweep
step Rate. The Mode has to be set to Sweep for sweep setting to take effect.
Figure 6 Sweep Page
Sweep/Mode; CW, Sweep, or List modes are selected and displayed. This bar is a global
element of the CM and will be shown on the Main and List pages as well.
Sweep/Start Freq; Set sweep start frequency.
Sweep/Stop Freq; Set sweep stop frequency.
Sweep/Step Freq; Set sweep step size.
Sweep/Rate; Set sweep step rate (milliseconds).
Valon Technology 5009a Operations Manual – Version 1.38 Page 20