Seanet Pro Operation; Seanet Setup For Gemini - Gemini 720id Product Manual

7. Seanet Pro Operation

Before starting operations, run Seanet Setup to verify that the Gemini LAN is enabled and
any connected devices, including the Gemini sonar, are detected. In Seanet Pro, the Gemini
Sonar has been allocated the node range from 100 to 103.

7.1. Seanet Setup for Gemini

Click on Gemini LAN from the Setup menu.
Figure 7.1.
This will open the Gemini Setup page.
Figure 7.2.
Gemini Setup
Network Enabled
Number of Sonars Detected
Selected Sonar
Selected Sonar Details
Document: 0685-SOM-00001, Issue: 12
Note
This section details the aspects of Seanet Pro that are specific to the Gemini
Sonar. For more general information (particularly if integrating with other
devices) please see the Seanet Pro Software Manual which is available online
at www.tritech.co.uk
Ensure this box is ticked to load the Gemini Connection
DLL and start the Gemini Network. The box can remain
permanently ticked thereafter.
When the network is enabled, this will display the
number of Gemini Sonars that are currently detected and
broadcasting on the network.
The drop-down list will display the ID Numbers of all the
Gemini Sonars currently connected. Select the Gemini
Sonar that you wish to configure.
When the selected item in the 'Selected Sonar' drop-
down list is changed, the details of that particular Gemini
Sonar will be displayed here. These details include;
56
Gemini Imaging Sonar
© Tritech International Ltd.