Online Button - Gemini 720id Product Manual

Gemini Software Operation
On the lower left hand side of the screen are the range and gain controls for the sonar.
On the lower right hand side of the screen are the indicators showing the pointer position
within the display area.

5.1.2. Online Button

If the Online button is pressed while no heads are visible to the Gemini software, the
following message will be displayed.
Clicking OK will acknowledge the message, and the software will not go online.
If the Sonar ID entered in the Sonar box of the configuration settings is not one of the heads
visible to the Gemini software when the Online button is pressed, the software will present
one of two messages.
If only one head is visible, the software will offer the chance to start imaging from that head.
Clicking Yes will cause the software to select the head which is visible to it. Clicking No will
acknowledge the message, and the software will not change the selected head and will not
go online.
If there are multiple heads that are available, the software will display a message asking you
to change the Sonar ID to one of the detected units.
Document: 0685-SOM-00001, Issue: 12
Note
If serial sensor data is available and enabled from the Advanced tab, a subset
of the data will be shown at the bottom of the User screen as well.
The Online button starts communication with the Gemini head. When the
software is started the head will not be running and the Online button will
be grey.
Clicking the Online button will start the Gemini head; the button and the sonar
cone image next to it will change to green. Clicking the button a second time
will stop communication with the head, and the button and sonar cone will
return to grey.
27
Gemini Imaging Sonar
© Tritech International Ltd.