Attaching The Light - Good Earth Lighting SE1291-BP2-02LF0-G Manual

Fastening the mounting screw
5
IMPORTANT
THE PIR CONTROL PANEL SHOULD FACE DOWNWARD TOWARD THE GROUND FOR EASY ACCESS.

Attaching the Light

Sensor Head
AIM THE PIR SENSOR TOWARD THE INTENDED DETECTION AREA.
Align the center hole of the fixture
and the mounting strap. Insert the
long mounting screw and fasten it
until the light is secure to the
junction box.
CAUTION
DO NOT PINCH WIRES WHEN
TIGHTENING DOWN.
DO NOT OVER TIGHTEN.
Verify light works
6
ON
Restore power to the junction box and verify the
wiring is correct.
IMPORTANT
daylight hours, it may be necessary to block the light from
the sensor head by blocking the light from it by covering it
with a dark towel or sock. This will enable the light to
activate. Should the light still not turn on, refer to the wiring
section and recheck the wire connections.
Adding the plug
7
Insert the translucent silicone plug into the
center mounting hole.
Verify the light switch is in the
"ON" position first. During
7