How To Wire The Light - Good Earth Lighting SE1291-BP2-02LF0-G Manual

DANGER!
3 WAYS
TO MOUNT:
WALL MOUNT
EAVE MOUNT
BOX MOUNT
Insert junction box wires into the
electrical box connector
2
NOTE: Ground wires are normally a green insulated or bare copper wire.

How To Wire the Light

SHUT OFF POWER TO THE JUNCTION BOX
BEFORE INSTALLING THE FIXTURE.
Attaching the mounting strap to junction box
1
Using two small or
medium box
screws, attach the
mounting strap to
the junction box
and pull the ends of the supply wires out of the junction
box.
For Surface Box Mounting ONLY:
Remove the protective liner from the gasket, align
the center hole of the gasket with that of the
mounting strap, and apply the gasket to the outer
edge of the surface mounting box as shown.
BLACK
LIVE
Insert the wires into
either the top or
bottom contact hole
for each color.
Works with most electrical boxes styles
WHITE RED
NEUTRAL GROUND
The side stamped "FRONT" needs
to face away from the junction box
CAUTION
WIRES MUST BE FULLY
INSERTED INTO THE
CONTACT HOLES.
5