Table of Contents
Advertisement
4. Software Description
This chapter introduces the firmware debugging of HLK-LD2420 and the use of the upper
computer tools.
The HLK-LD2420 is shipped with burned-in system firmware, the firmware version is detailed in
the module package. Hailing Technology provides visualization and configuration software for HLK-
LD2420 hardware, which is convenient for developers to configure HLK-LD2420 parameters
according to the usage scenarios and optimize the sensing effect.
4.1. Firmware Configuration
This section describes how to debug the HLK-LD2420 radar module firmware.
Step 1、The USB to TTL serial adapter board is used to connect the host computer to the radar
module, and the pin connections are shown in Table 4-1 and Figure 4-1. shown in Table 4-1 and
Figure 4-1.
Table 4-1 Correspondence of pins when connecting the radar to the USB serial adapter board
Radar Module
Figure 4-1 Connection between HLK-LD2420 hardware and USB serial port adapter board
Step 2、Open the Device Manager of the host computer and check the serial number of the serial
port where the radar module is located.
Step 3、Open the serial port tool, select the serial port number of the radar module, set the serial
port baud rate to 256000, and then click the "Open Serial Port" button to view the current radar
detection results on the output side of the tool interface.
HLK-LD2420
RX
O_T2
3V3
GND
第 5 页 共 14 页
Serial port adapter board
TXD
RXD
VCCIO
GND
User Manuals
Hide quick links:
Advertisement
Table of Contents
