Blind Hemming - Janome 2030DC-T Instruction Book

q w
z
(1)
q
x
c
(1)
q
e
(2)
w
q
r
e
(2)
w

Blind Hemming

q Stitch pattern:
w Thread tension dial:
e Presser foot:
z Fold a hem with the wrong side of the fabric up to
form a 1/8˝ – 1/4˝ (0.4 – 0.7 cm) allowance.
q Wrong side of fabric
w
w 1/8˝ – 1/4˝ (0.4 – 0.7 cm)
(1) On heavyweight fabrics that tend to ravel, the raw
edge should be overcast first.
(2) Fold the hem under the fabric for lightweight
fabrics.
x Place the fabric so that the fold is next to the guide on
the foot. Lower the presser foot. Adjust the needle
drop position if necessary. Sew while guiding the fold
along the guide.
e Fold
r Guide
c Open the fabric after sewing is finished.
NOTE:
If the needle pierces too far left, the stitch will show
through on the right side of the fabric.
• Adjusting the needle drop position
Press the cursor buttons
the stitch width value "0.6" (default setting).
(1) Press the
to the right.
(2) Press the
to the left.
The LCD display shows the distance between the guide
and left needle drop position in millimeters.
The needle drop position can be varied from 0.0 to 1.2.
q Left needle drop position
w Guide
NOTE:
The needle drop position can be varied, but the stitch
width will remain the same.
34
10
1 to 4
Blind Hem foot G
to move the cursor under
button to move the needle drop position
button to move the needle drop position