Table of Contents
Advertisement
q
w
e
4
z
(1)
w
q
x c
v
(2)
w
q
r
e
q
44
Blind Hemming
q Stitch pattern:
w Thread tension dial: 1 to 4 (for stitch pattern 12)
e Presser foot:
z Fold a hem with the wrong side of the fabric up to
form a 0.5 cm (1/4˝) allowance.
q Wrong side of fabric
w 0.5 cm (1/4˝)
(1) On heavyweight fabrics that tend to ravel, the raw
edge should be overcast first.
(2) Fold the hem under the fabric for lightweight
fabrics.
x Place the fabric so that the fold is next to the guide on
the foot.
Lower the presser foot.
Adjust the needle drop position if necessary.
c Sew while guiding the folded edge.
e Folded edge
r Guide
v Open the fabric after sewing is finished.
NOTE:
If the needle pierces too far left, the stitch will show
through on the right side of the fabric.
Adjusting the needle drop position
Adjust the needle drop position as follows:
Press the "–" sign on the stitch width adjusting key q to
move the needle to the right.
Press the "+" sign on the stitch width adjusting key q to
move the needle to the left.
q Stitch width adjusting key
The LCD display shows a distance from the center
needle drop position in millimeters.
The needle drop position can be varied from 0.0 to 1.2.
NOTE:
The needle drop position can be moved, but the stitch
width will remain the same.
12 or 13
3 to 6 (for stitch pattern 13)
Blind hem foot G
Advertisement
Table of Contents
