Table of Contents
Advertisement
q
w
e
4
z
(1)
w
q
x c
v
q
(2)
w
q
e
w
36
Blind Hemming
q Stitch pattern:
w Thread tension dial: 1 to 4 (pattern 12)
e Presser foot:
z Fold a hem with the wrong side of the fabric up to
form a 1/4˝ (0.5 cm) allowance.
q Wrong side of fabric
w 1/4˝ (0.5 cm)
(1) On heavyweight fabrics that tend to ravel, the raw
edge should be overcast first.
(2) Fold the hem under the fabric for lightweight
fabrics.
x Place the fabric so that the needle just pierces the
folded edge when the needle comes over the extreme
left side.
Lower the presser foot.
Adjust the needle drop position if necessary.
c Sew slowly while guiding the folded edge.
e Folded edge
v Open the fabric after sewing is finished.
NOTE:
If the needle pierces too far left, the stitch will show
through on the right side of the fabric.
Adjusting the needle drop position
Adjust the needle drop position as follows:
Press the mode key q to select the stitch width
adjustment mode (
Press the " " sign on the value set key w to move the
needle to the right.
Press the " " sign on the value set key w to move the
needle to the left.
q Mode key
w Value set key
The needle drop position can be varied from 0.0 to 1.2.
NOTE:
The needle drop position can be moved, but the stitch
width will remain the same.
12 or 13
3 to 6 (pattern 13)
Zigzag foot A
).
Advertisement
Table of Contents
