Key Tones; Before First Use; The Salt Container - Zanussi ZDLN6531 User Manual

AirDry is automatically activated with all
programmes other than Pre-rinse.
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
When AirDry opens the door, the display shows the
remaining time of the running programme.
CAUTION! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
CAUTION! If children have access to
the appliance, we advise to deactivate
AirDry. The automatic opening of the
door may pose a danger.
When AirDry opens the door, Beam-
on-Floor might not be completely
visible. To see if the programme is
complete, look at the control panel.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30 min to remove any
residuals from the manufacturing process. Do
not use detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.

THE SALT CONTAINER

CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
12

KEY TONES

The buttons on the control panel make a click
sound when you press them. You can deactivate
this sound.
LATEST PROGRAMME SELECTION
You can set the automatic selection of the most
recently used programme and options.
The latest programme that was completed before
the appliance deactivation is saved. It is then
selected automatically after you activate the
appliance.
When the latest programme selection is disabled,
the default programme is ECO.
2. Put 1 litre of water in the salt container (only for
the first time).
3. Fill the salt container with 1 kg of salt (until it is
full).
4. Carefully shake the funnel by its handle to get
the last granules inside.
5. Remove the salt around the opening of the salt
container.