Frame Separation; Assembly - ONE Limosa Owner's Manual

7.3 Frame Separation

Identi cation key
1. Frame Hook
2. Lower Frame Tube
1. With the seat and battery pack removed (see Disassembly Procedures on
previous page), lower the tiller and tighten the tiller adjustment knob. See
2. Lift up the frame release lever and move the front frame going forward
until the front frame hooks are no longer resting on the rear frame tube.
3. Slowly separate the two parts of the Travel Scooter. See gure 8.

7.4 Assembly

1. Use the front frame release lever to lift the front frame as you align the
frame hooks of the front frame with the rear frame tube of the rear frame.
See gure 8.
2. Once the frame hooks are over the rear frame tube, lower the front frame
and pivot the rear frame simultaneously. This will engage the frame
lock-up automatically. See gure 8.
3. Raise the tiller and fully secure the tiller adjustment knob. See gure 4.
4. Reinstall the battery pack.
5. Reinstall the seat and rotate it until it is secured into place.
29
ver 2023.01.03E
ATTENTION – Before attempting assembly, tilt the
rear half of the Travel Scooter slightly back on the
anti-tip wheels as shown in gure 8.
gure 4.
Mobility Scooter
OWNER'S MANUAL
Figure 8. Frame Release Level