Table of Contents
Advertisement
Installing the LightPulse Utility
The LightPulse Utility, LpUtilNt (described in
Utilities, on page 37) does not automatically load. HP recommends that after
loading the HBA driver, you install LpUtilNt as follows:
1. Browse to the LighPulse folder on the Smart Setup CD-ROM (or to one
2. Double-click cp00xxxx.exe.
Note:
final version number:
http://h18000.www1.hp.com/storage/saninfrastructure.html.
3. Follow the installation wizard instructions.
4. After the installation completes, you can start the LightPulse Utility by
AB466A and AB467A PCI-X Host Bus Adapters for 64-Bit Windows Systems Installation Guide
downloaded from the web site if it is more recent).
Refer to the following web site for the information about this Smart Component's
choosing Start > Programs > LpUtilNt.
Installing the SCSI Miniport Driver
Diagnostic and Configuration
27
Advertisement
Table of Contents
