Table of Contents
Advertisement
Installation
Verifying the Installation
To verify the HBA is properly installed and is operating:
1. Turn on the computer.
2. At power up, observe the POST LED indicators on the HBA. The position of
Table 3: Normal POST LED Indicators
Amber LED (L1)
Off
On
Slow blink (1 Hz)
Fast blink (4 Hz)
Flashing (irregular)
Off
On
Slow blink (1 Hz)
Fast blink (4 Hz)
Off
22
AB466A and AB467A PCI-X Host Bus Adapters for 64-Bit Windows Systems Installation Guide
the POST LED indicators is shown in
page 15. The green LED indicates power functions and the amber LED
signifies port activity. The amber LED blinks at all times during normal
operation.
Table 3
lists normal LED indications.
Figure 1
Green LED (L2)
Off
Wake-up failure (dead board)
Off
POST failure (dead board)
Off
Wake-up failure (dead board)
Off
Failure in POST (dead board)
Off
POST processing in progress
On
Failure while functioning
On
Failure while functioning
On
Normal—1 Gb link rate
On
Normal—2 Gb link rate
Blink (1 Hz)
Normal—link down or not yet
started
on page 15, and
Table 2
State
on
Advertisement
Table of Contents
