Replacing The Front Panel Assembly; Replacing The Display Module - Bosch Benchmark Series Service Manual

58300000181895 ARA EN A
6.5.1

Replacing the Front Panel Assembly

1. Remove power to the oven.
2. Protect the top of the oven door to prevent damage to the
stainless front panel or door.
3. Remove two screws on the underside of the panel assembly –
one on the right and one on the left – which secure the panel to
the vent trim; it is not necessary to remove the center screw at this
time.

NOTICE
Use care when detaching the front panel. There may be little slack in
the wires connecting the control module to the display board and the
control module to the touch pad, so it may not be possible to fully
rotate the front panel 90°.
4. Carefully swing the bottom of the control panel outward, then lift to
disengage the side flanges of the front panel carrier from the slots
in the side trim.
Figure 36 Detaching the control panel from the side trims
5. Disconnect the ground wire and the communication harness
connectors at the display board and touch pad; set the front panel
on a flat work surface.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
6. Remove the screw in the bottom center of the panel, which
secures the panel to the carrier directly behind it.
7. Separate the carrier from the front panel assembly.
Figure 37 Front panel assembly (top) separated from carrier (bottom) with display module attached
8. Reassemble the control panel using the new front panel service
assembly.
9. Reattach the control panel, restore power, and test operation.
6.5.2
The display module is mounted to the control panel carrier by four
tabs that protrude from the carrier. The tabs are twisted slightly after
mounting the board to secure the board in place.
Figure 38 Display board secured to carrier with the carrier's 4 metal tabs that are twisted slightly
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Replacing the Display Module

Page 26 of 45
800 944-2904