2-Thread Subsidiary Looper - Baby Lock Victory BLS3 Instruction And Reference Manual

2-Thread Subsidiary Looper

1
1
Either needle thread may be engaged for 2-thread overlock se-
A A
wing.
To engage the subsidiary looper
1. Open the front cover and the blade cover, cut the upper lo-
oper thread just above the threading port. (fig. A) Raise the
presser foot and pull out the clipped thread from under the
foot.
B B
2 Remove the upper looper thread from the machine.
1 2. Rotate the handwheel to bring the needle clamp to its highest
position.
3. Slide the subsidiary looper to the right direction and swing it
counterclockwise to the left. (fig. B)
4. Make sure the hooked tip of the subsidiary looper enters into
the upper looper eye. (fig. C)
5. Close the blade cover and the front cover.
C C
To disengage the subsidiary looper
1. Open the front cover and the blade cover.
2. Rotate the handwheel to bring the needle clamp to its highest
position.
3. Slide the subsidiary looper to the left direction and swing it
clockwise to the right. (fig. D)
4. Make sure the subsidiary looper is resting at the right side of
2
D D
the upper looper. (fig. E)
5. Close the blade cover and the front cover.
E E
O
V
E
R
V
I
E
W
13