2-Thread Subsidiary Looper - Baby Lock Celebrate BLS1 Instruction And Reference Manual

O

2-Thread Subsidiary Looper

V
E
R
V
I
E
W
1
13
Either needle thread may be engaged for 2-thread overlock
A
sewing.
To engage the subsidiary looper
1. Open the front cover and the blade cover, cut the upper
B
2
1
2. Rotate the handwheel to bring the needle clamp to its
3. Slide the subsidiary looper to the right direction and
4. Make sure the hooked tip of the subsidiary looper enters
5. Close the blade cover and the front cover.
C
To disengage the subsidiary looper
1. Open the front cover and the blade cover.
2. Rotate the handwheel to bring the needle clamp to its
3. Slide the subsidiary looper to the left direction and swing
2
D
4. Make sure the subsidiary looper is resting at the right
5. Close the blade cover and the front cover.
E
looper thread just above the threading port. (fig. A) Raise
the presser foot and pull out the clipped thread from
under the foot.
Remove the upper looper thread from the machine.
highest position.
swing it counterclockwise to the left. (fig. B)
into the upper looper eye. (fig. C)
highest position.
it clockwise to the right. (fig. D)
side of the upper looper. (fig. E)