Continental Fireplaces CBI 360-N Installation And Operation Instructions Manual
  1. Manuals
  2. Brands
  3. Continental Fireplaces Manuals
  4. Indoor Fireplace
  5. CBI 360-N
  6. Installation and operation instructions manual

Continental Fireplaces CBI 360-N Installation And Operation Instructions Manual

Gas-fired vented fireplace
Hide thumbs Also See for CBI 360-N:
Table of Contents

Advertisement

Quick Links

See also: Install and Operation Instructions
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.22, AND ANSI Z21.50 RESPECTIVELY FOR VENTED GAS FIREPLACES.
INSTALLATION AND OPERATION INSTRUCTIONS FOR
WARNING: If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity of
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
Installation and service must be performed by a qualified installer, service agency
GAS - INSERTS
GAS-FIRED VENTED FIREPLACE
NATURAL GAS MODEL
PROPANE GAS MODEL
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / CSA METHODS
FOR YOUR SAFETY
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
or the gas supplier.
CBI 360 - N
CBI 360 - P
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
1
W415-0120 / E / 01.11.05

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CBI 360-N and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Continental Fireplaces CBI 360-N

Summary of Contents for Continental Fireplaces CBI 360-N

  • Page 1 CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.22, AND ANSI Z21.50 RESPECTIVELY FOR VENTED GAS FIREPLACES. INSTALLATION AND OPERATION INSTRUCTIONS FOR GAS-FIRED VENTED FIREPLACE NATURAL GAS MODEL PROPANE GAS MODEL CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / CSA METHODS WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

  • Page 2: Table Of Contents

    TABLE of CONTENTS PG 2-5 INTRODUCTION Warranty General Instructions General Information Care of Glass, & Plated Parts 5-6 INSTALLATION 7-8 FINISHING Brick panels Log Placement/Charcoal Embers Louvre Installation Logo Placement OPERATION / MAINTENANCE Spill Switch Venting Action Check PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE Do not burn wood or other materials in this fireplace.
  • Page 3 W415-0120 / E / 01.11.05...

  • Page 4: General Instructions

    Do not use abrasive cleaners to clean plated parts. Buff lightly with a clean dry cloth. The glass is 3/16" ceramic glass available from your Continental / Wolf Steel Ltd. dealer. Do not substitute materials. Clean the glass after the first 10 hours of operation with a recommended gas fireplace glass cleaner.

  • Page 5: Installation

    FIGURE 1 Clean out ashes from the inside of the wood-burning fire- place. Make sure that the chimney and wood-burning fire- place are in a clean and sound condition and constructed of non-combustible materials. If necessary have any repair work done by a qualified person before installing the in- sert.
  • Page 6 An on/off switch has been included and can be located at the right side trim. For ease of accessibility, this switch may be replaced with a wall switch or substituted with a millivolt thermostat that may be installed in a convenient location on any wall.

  • Page 7: Fibre Firebrick Panels

    Fine dust found in bottom of bag not to be used. PHAZER logs and charcoal embers glow when exposed to direct flame. Use only certified PHAZER coal embers available from your Continental / Wolf Steel Ltd. dealer. FLUSH LOUVRE KIT, GI-1L SIDE VIEW...

  • Page 8: Logo Placement

    " LOGO " OPERATION / MAINTENANCE SPILL SWITCH This is a thermally activated switch, attached to the back of the unit and extending up into the dilution draft hood, which senses the change in temperature and shuts down the gas valve in the event of a severe downdraft of air or a blocked or disconnected vent.

  • Page 9: Maintenance

    A 5 to 10 second total light-up period is satisfactory. If ignition takes longer, consult your Continental dealer / dis- tributor. 7. Check that the door gasketing is not broken or missing.

  • Page 10: Blower System

    The Continental gas fireplace insert comes standard with a blower, a heat sensor, variable on/off speed control and a power cord. Because the blower is thermally activated, when turned on, it will automatically start approximately 15 minutes after lighting the fireplace and will run for approxi- mately 30 minutes after the fireplace has been turned off.

  • Page 11: Replacements

    Contact your dealer for questions concerning prices and availability of replacement parts. Normally all parts can be ordered through your Continental dealer or distributor. FOR WARRANTY WARRANTY REPL WARRANTY WARRANTY WARRANTY REPLA A A A A CEMENT REPL REPL REPL...
  • Page 12 W415-0120 / E / 01.11.05...

  • Page 13: Trouble Shooting Guide

    TROUBLE SHOOTING GUIDE EFORE ATTEMPTING TO TROUBLESHOOT PURGE YOUR UNIT AND INITIALLY LIGHT THE PILOT AND THE MAIN BURNER WITH THE GLASS DOOR REMOVED SYMPTOM PROBLEM Pilot goes out when System is not correctly purged. the gas knob is re- Out of propane gas.
  • Page 14 SYMPTOM PROBLEM Main burner goes out; Refer to "Main burner goes out; pilot stays on" pilot goes out. Chimney down-drafting Chimney is blocked Liner disconnected from insert. Faulty spill switch. Pilot flame is not large enough Main burner goes out; or not engulfing the thermopile.
  • Page 15 W415-0120 / E / 01.11.05...
  • Page 16 NOTES W415-0120 / E / 01.11.05...

This manual is also suitable for:

Cbi 360-p

Table of Contents

Save PDF