Maxwell MW-2023 GY - Dryer Manual

INTRODUCTION

The hairdryer is intended for hair drying and styling.

DESCRIPTION

1. Air supply speed switch (0/ /
2. Heating degree switch ( / / )
3. Cool shot button
4. Nozzle
5. Air inlet grid
6. Ionization indicator
7. Handle
8. Hanging loop
9. Diffuser

ATTENTION

• Do not use the unit near containers filled with water (such as bath, swimming pool etc.) and in wet basements.
• After using the hairdryer in a bathroom, pull the power plug out of the mains socket, as water closeness is dangerous even if the unit is switched off with the switch.
• For additional protection you can install a residual current device (RCD) with nominal operation current not exceeding 30 mA into the bathroom mains; when installing, contact a specialist.

SAFETY MEASURES

Before using the unit, read these instructions carefully and keep them for further reference. Use the unit according to its intended purpose only, as it is stated in this user manual. Mishandling the unit can lead to its breakage and cause harm to the user or damage to his/her property.

• Before using the unit for the first time, make sure that voltage in your mains corresponds to the voltage of the unit.
• To avoid fire, do not use adapters for connecting the unit to the mains.
• Do not immerse the power cord and power plug into water or other liquids.
• Do not touch the unit body and the power plug with wet hands.
• Before using the unit, closely examine the power cord and make sure that it is not damaged. Never use the unit if the power cord or the power plug is damaged, the unit works improperly or after it was dropped. Contact an authorized service center for all repair issues.
• When using the unit, we recommend to unwind the power cord to its full length.
• The power cord should not:
  • touch hot objects,
  • run over sharp edges,
  • be used as a handle for carrying the unit.
• Use only the attachments supplied.
• Do not switch the unit on in places where aerosols are sprayed or highly inflammable liquids are used.
• Hair spray should be applied only after hair styling is finished.
• Do not operate the unit while taking a bath.
• Never leave the operating unit unattended.
• Take the switched on hairdryer by its handle only.
• Do not place and do not keep the unit in places, where it can fall into a bath or a sink filled with water, do not immerse the unit into water or any other liquids.
• If the unit was dropped into water, unplug it immediately. And only then you can take it out of water.
• Do not use the unit when you are drowsy.
• Do not use the unit to style wet hair or synthetic wigs.
• Avoid contact of heated surfaces with your face, neck and other parts of your body.
• Never block the air inlets of the hairdryer, do not place it on a soft surface, such as a bed or couch, where the air inlets may be blocked. Keep the air inlets free of lint, dust, hair etc.
• Never insert any foreign objects into the unit body openings.
• Avoid getting of hair into the air inlet grid during operation of the unit.
• Do not direct hot air into your eyes or other heatsensitive parts of your body.
• The attachments get hot during use. Let them cool down before removing from the unit body.
• Never leave the operating unit unattended. Unplug the unit before cleaning and when you do not use it.
• Never pull the power cord, when disconnecting the unit from the mains, take the power plug and carefully remove it out from the mains socket.
• Clean the unit regularly.
• Do not allow children to touch the unit body and the power cord during the unit operation.
• This unit is not intended for usage by children under 8 years of age.
• This unit is not intended for usage by people (including children over 8) with physical, neural, mental deviations or with insufficient experience or knowledge. Such persons can use this unit only if they are under supervision of a person who is responsible for their safety and if they are given all the necessary and understandable instructions concerning the safe usage of the unit and information about danger that can be caused by its improper usage.
• Do not leave children unattended not to let them use the unit as a toy.
• For children safety reasons do not leave polyethylene bags, used as a packaging, unattended. Attention! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!
• Transport the unit in the original package only.
• Keep the unit out of reach of children and disabled persons.

Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!

• Transport the unit in the original package only.
• Keep the unit out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY

USING THE HAIRDRYER

After unit transportation or storage at low temperature, it is necessary to keep it for at least two hours at room temperature before switching on.

• Unpack the unit and remove any stickers that can prevent unit operation.
• Unwind the power cord completely.
• Before switching the unit on, make sure that your home mains voltage corresponds to unit operating voltage.
• Insert the power plug into the mains socket.
• Use the switch (1) to set the required air supply speed:
  «0» – the hairdryer is off,
  - low speed,
  - high speed.
  
• Set the required temperature of the air flow using lthe switch (2):
  - low heating,
  - medium heating,
  - maximal heating.

Note:
During the first operation some foreign smell and a small amount of smoke from the heating element is possible, this is normal.

• This model has a "cool" air supply function, use it for fixing your hair. For cool air supply switch the hairdryer on, then press and hold the button (3) .

Ionization

A built-in generator produces negatively charged ions, which reduce the static charge in the hair and increase absorption of moisture by the hair, preventing it from getting too dry during hairstyling, and making it look healthy and well-groomed.
When the unit is switched on, the ionizer operates and the indicator (6) lights up.

Hair care

To get the best results, wash your hair with shampoo (before drying and styling), remove excessive moisture with a towel and comb your hair.

Quick drying

Set the switch (2) to the maximal heating position , select the required air supply speed using the switch (1) and dry your hair. Shake off excessive moisture from the hair with your hand or a comb and constantly move the hairdryer above your hair.

Straightening

Set the switch (2) to the maximal heating position , select the supply speed using the switch (1) and preliminarily dry the hair. When the hair is almost dry, set the nozzle (4) decrease the heating degree with the switch (2) and the air flow speed with the switch (1). Divide your hair into locks and layers. Start straightening from the lower layers. Using a plain or a round comb, brush the hair downwards and simultaneously direct hot air from the nozzle (4) at your hair. This way, carefully straighten each lock from root to end. After straightening the lower locks, straighten the locks of the middle layer and finish with locks of the upper hair layer.

Natural locks

Set the switch (2) to the low heating position , select the low air supply speed, setting the switch (1) to the position , grip locks between fingers tightly, turn them in the direction of natural curling and dry them directing air between fingers. Fix the locks with «cool» air, pressing and holding the button (3) . You can also use the diffuser attachment (9) for making natural wavy hair.

Styling

Set the switches (1, 2) to the low heating and low speed positions and attach the nozzle (4) to the hairdryer.
After dividing your hair into locks create a required hair style by means of a round hair-brush. Direct the air flow straight onto your hair.
If necessary, direct the «cool» air flow at the lock for 2-5 seconds to fix it. Styling time is determined individually according to hair type; you can determine it by yourself.

Overheating protection

Overheating protection switches the hairdryer off if the outgoing air is too hot. If the hairdryer is switched off during operation, set the switch (1) to the «0» position, unplug the hairdryer and make sure that the inlets and outlets are unblocked. Let the hairdryer cool down for 5-10 minutes and then you can switch it on again. Do not block the air inlets during unit operation and avoid getting of hair into its air inlet.

CLEANING AND CARE

The hairdryer is intended for household usage only.

• Set the switch (1) to the «0» position, disconnect the hairdryer from the mains and let it cool down.
• Clean the unit body with a slightly damp soft cloth, and then wipe it dry.
• Turn the air inlet grid (5) counterclockwise and remove it from the unit body. Clean it with a brush and install back to its place.
• Never immerse the unit into water or other liquids.
• Do not use abrasives and solvents to clean the unit body.

STORAGE

• Disconnect the unit from the mains and clean it.
• Never wind the power cord around the hairdryer, as this can damage the cord. Handle the power cord with care, do not pull, twist or stretch it, especially near the power plug or at the junction point. Straighten the cord if it gets twisted during hairdryer operation.
• You can store the hairdryer hanging it by the loop (8) provided that no water gets on it in this position.

DELIVERY SET

Hairdryer – 1 pc.
Nozzle – 1 pc.
Diffuser - 1 pc.
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50/60Hz
Power consumption: 1800-2200 W

The manufacturer preserves the right to change the specifications of the unit without a preliminary notification.
Unit operating life is 3 years

Guarantee

Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

This product conforms to the EMC- Requirements as laid down by the Council Directive 2004/108/EC and to the Law Voltage
Regulation 2006/95/EC

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Maxwell MW-2023 GY - Dryer Manual