DIP Switches
You must reset the NI CVS-1450 device in order for the setting change to occur.
Note
© National Instruments Corporation
Figure 2-2 shows the location of the 10/100 Mbps LED on the
NI CVS-1450 device.
Figure 2-2. ACT/LINK and 10/100 Mbps LEDs
This section describes the SAFE MODE, IP RESET, NO APP, and
USER 1 DIP switches on the NI CVS-1450 device.
To enable a DIP switch, move the switch to the ON (left) position and then
reset the NI CVS-1450 device by pressing the RESET button for at least
two seconds.
Chapter 2
2-3
LEDs, DIP Switches, and Connectors
NI 1454
Compact Vision System
NI CVS-1450 Series User Manual