Remote Control; Setup Menu - Yamaha R-N500 Service Manual

▼ ADVANCED SETUP MENU
Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
RETURN
While holding down
(power).
panel, press
(power)
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press (power) to set the unit to turn off and
turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
Item
Changes the speaker impedance setting.
SP IMP.
Selects the unit's remote control ID.
REMOTE ID
Restores the default settings.
INIT
Updates the firmware.
UPDATE
Checks the version of firmware
VERSION
currently installed on the unit.
Changing the speaker impedance
setting (SP IMP.)
on the front
RETURN
Change the unit's speaker impedance settings depending
on the impedance of the speakers connected.
Settings
4 Ω MIN
SELECT/ENTER
8 Ω MIN
(default)
Selecting the remote control ID
(REMOTE ID)
Change the unit's remote control ID so that it matches the
remote control's ID (default: ID2). When using multiple
Yamaha AV receivers, you can set each remote control
with a unique remote control ID for its corresponding
Function
receiver.
Settings
ID1, ID2 (default)
1
The registered remote control codes are not cleared even if
you change the remote control ID.
S P I M P . 8 M I N
Select this option when you connect 4-ohm
speakers to the unit.
Select this option when you connect 8-ohm or
higher speakers to the unit.
R E M O T E I D I D 2
Changing the remote control ID of the

remote control

To select ID1, while holding down the ID, hold
down numeric key "1" for more than 3
seconds.
To select ID2, while holding down the ID, hold
down numeric key "2" for more than 3
seconds.
Once the remote control code is successfully
registered, "Rem: Success" appears on the front
display.
If "Rem: Fail" appears on the front display,
registration has failed. Repeat from Step 1.
R-N500
97