Yamaha R-N500 Firmware Update
Hide thumbs
Also See for R-N500:
- Owner's manual (420 pages) ,
- Owner's manual (20 pages) ,
- Service manual (100 pages)
Advertisement
Quick Links
IMPORTANT NOTICE
Follow the instructions carefully and do not attempt any other procedures not specified in the instructions
provided by Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to restore
proper operation will not be covered under the Yamaha Limited Warranty.
Choose from the following 2 methods to update to the latest firmware.
Click here for
[ 1. Firmware Update Through the Internet ]
Requirements:
Your R-N500 is connected to the Internet if you can receive
Internet radio stations. (See owner's manual for details)
POWER
STEP 1
Turn off the unit.
STEP 2
While holding down RETURN on the front panel, press power.
STEP 3
"ADVANCED SETUP" will be shown for seconds.
STEP 4
Rotate SELECT/ENTER to select firmware update mode as shown below.
Firmware Update Procedure for R-N500
Firmware Update Through the Internet
(Connection to the Internet is required)
Click here for
(A USB thumb drive is required)
In case of error, see the
DIMMER
Firmware Update by USB
Troubleshooting
DISPLAY
SELECT/ENTER
section
RETURN
Advertisement
Related Manuals for Yamaha R-N500
Summary of Contents for Yamaha R-N500
- Page 1 In case of error, see the Troubleshooting section [ 1. Firmware Update Through the Internet ] Requirements: Your R-N500 is connected to the Internet if you can receive Internet radio stations. (See owner’s manual for details) DIMMER DISPLAY RETURN POWER...
- Page 2 DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the R-N500 will restore original firmware. Perform the update procedure from STEP 1 again. STEP 7 Confirm updated firmware version Retry from STEP 2 to enter “ADVANCED MODE”.
- Page 3 Firmware Update Procedure for R-N500 DIMMER DISPLAY RETURN POWER SELECT/ENTER STEP 1 Turn off the unit. STEP 2 Insert the USB thumb drive on the front panel. STEP 3 While holding down RETURN on the front panel, press power. STEP 4 “ADVANCED SETUP”...
- Page 4 DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the R-N500 will restore original firmware. Perform the update procedure from STEP 1 again. STEP 7 Confirm updated firmware version Retry from STEP 2 to enter “ADVANCED MODE”.