Table of Contents
Advertisement
ACT 5e prox Operating and Installation Manual
• Remember to Factory Default the ACT 5e prox before programming.
• Remember to place the supplied varistor across the terminals of the door strike coil to protect
the relay contacts.
• Don't mount the ACT 5e prox unit near RF sources (e.g. mobile phones, radio transmitters, etc)
or metal surfaces.
• Never use the on-board relay to switch AC mains voltage. An external relay, electrically
isolated from the ACT 5e prox, should be used for this purpose.
• Remember to change the programming code.
• When ordering new cards or fobs specify ACTRFID. (Note: ACT 5e prox will NOT work with
HID cards or fobs.)
As with any Access Control system, always ensure there is an alternate means of escape in the
event of the unit failing to operate due to power loss or in the event of fire.
Number of Users
Supply Voltage
Current Consumption
Operating Temperature
Door Open Time
Relay Contact Rating
Keypad Size
Keypad Weight
Water Resistance
Construction
Product
Proximity card
Proximity fob
Proximity half shell card
Proximity card with magnetic stripe
Installation Notes
Important
Product Specification
50 (50 PINs and 50 Cards)
12 - 24 V AC or DC (linear PSU)
60mA (nominal), 100mA (maximum)
-10 to +50 degrees C
0 - 255 seconds
5A / 50Vac
Flush Mount: 100 x 110 x 20mm
Surface Mount: 128 x 94 x 18.5 mm
220 grams
High IP67
Rugged Polycarbonate housing with stainless
steel keys and potted electronics.
Ordering Information
Product Code
ACTProx ISO-B
ACTProx Fob-B
ACTProx HS-B
ACTProx DUO-B
- 2 -
Rev 1.0
Advertisement
Table of Contents
