Footswitch Operation; Replacing The Fuse; Fixture Cleaning - Beamz SHOWBAR Instruction Manual

If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right (1)
and at the same time remove the battery support (2). For operation, one 3 V button
cell type CR 2025 is required. When inserting, pay attention that the positive pole of
the button cell shows upwards in the support.

FOOTSWITCH OPERATION

The included wireless footswitch provides quick access to preset colours, colour-change programs, auto and sound-activation
through the ShowBar microphone.
To use the footswitch:
- Set the ShowBar in footswitch mode.
- Point the antenna of footswitch and Showbar upstairs.
- Foot switch is ready for use, see the chart below chart for the functions.
Pedal Function
1 Auto mode
2 Sound mode
3 Colour
4 Black out

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:

FIXTURE CLEANING

The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
8
Foot
press
1
2
3
1
2
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Function
Auto program 1
Auto program 2
Auto program 3
Sound program 1
Sound program 2
Sound program 3
Red
Green
Blue
UV
Red / Green
Red / Blue
Red / UV
Green / Blue
Green / UV
Blue / UV
Red / Green / Blue
Red / Green / UV
Red / Blue / UV
Green / Blue / UV
Red / Green / Blue / UV
The blackout switch is used to turn off all Par and Butterfly.