Advertisement
T4700 CHRONOTHERM® ELECTRONIC PROGRAMMABLE LINE VOLTAGE THERMOSTAT
To change display or function (for example, to °C or
°F temperature setting, or to 7-day or 5-1-1
programming), see Additional Functions section.
Also, after programming is complete, the device
reverts to normal Run mode within five minutes, if
no key was pressed, and any new setting is stored
in its memory.
Function
Begin sequence
to convert display
or mode.
Convert to °C or
°F.
R
O
G
Convert 5-1-1 to
7 day .
NOTE: To exit the programming mode: 1) press and hold the Prog key for three seconds and the display
returns to Run mode, or 2) during the programming session, after five minutes elapsed time with
no program change, the display reverts to Run mode. This does not change any of the pro-
grammed steps. Simply keep pressing the Prog key until you arrive at the desired mode.
Table 2. Programming Additional Functions.
Key
P
P
R
U
O
N
G
E
P
P
R
O
G
Additional Functions
To program additional functions, see Table 2.
Display
Press and hold both the Prog and Func keys.
Initially a random four-digit/letter display occurs
(for example, FF FF).Continue to press Prog key
until temperature symbol appears.
Press Prog key a second time to display °C.
Use (+) key to change to °F if desired (or °F to
C°).
Press Prog key a third time to display 511d.
Press (+) key to change mode to 7-day
programming (or back to 5-1-1 programming).
Then adjust using the (+) or (-) keys.
3
Description
69-1395—1
Advertisement
