Machine Maintenance; Storing Machine; Recommended Stock Items - Castex LS-1700 Operator And Parts Manual

OPERATION
3. To move machine left (A), slightly lower handle. To
move right (B), slightly raise handle. Operate
machine with a side to side motion (Figure 10).
A
4. To stop machine, release triggers and safety lock
button will automatically engage.
FOR SAFETY: When using machine, do not
release handle grips until pad comes to a
complete stop.
NOTE: Circuit breaker may trip under conditions of
excessive overload. Periodically check pad for soil
build–up. To reset circuit breaker switch, wait 15
seconds and push reset button at side of handle.
5. When finished scrubbing perform the following
maintenance procedures:

MACHINE MAINTENANCE

WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
AFTER EACH USE:
1. Remove pad driver or brush.
2. Wash pads and brush.
3. Clean machine base.
4. Inspect power cord for damage, if worn or
damaged, replace immediately.
5. Wipe power cord with damp cloth and neatly coil
around cord hook and handle. To remove cord,
pull and turn cord hook upward.
6. Periodically check that all bolts and nuts are tight.
7. Every 250 hours of operation check motor carbon
brushes for wear. Replace brushes when 1 cm or
less in length.
6
B
FIG. 10
Home Find... Go To..

STORING MACHINE

1. Remove brush/pad driver from machine and neatly
coil cord around cord hook and handle.
2. Store in a dry area in the upright position.
3. For minimal storage or transport space, fold
handle down and position as shown
(Figure 11).
ATTENTION: Do not expose to rain. Store
indoors.

RECOMMENDED STOCK ITEMS

Refer to the Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description (Figure 12).
LS-1700/LS-1700HD/TS-1700HD/LS-2000/LS-2000HD/TS-2000HD (03–01)
FIG. 11
FIG. 12