Advertisement
Available languages
Available languages
WARNING!
This product is heavy and requires two persons for installation.
●
●
Installation work and electrical wiring must be done by qualified person(s)
●
●
in accordance with all applicable codes and standards.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
Preparing for installation:
1
Before installing your ventilation hood:
Read the instructions carefully.
●
●
Unpack the ventilation hood.
●
●
Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match
●
●
the voltage and frequency of the installation site.
Check that the area behind the installation surface to be drilled is clear of any
●
●
electrical cables or pipes etc
The ventilation hood surfaces can be damaged during installation if grazed or
●
●
knocked by tools. Please take care to protect the surfaces during installation.
Protect the cooktop surface with cardboard, or the like, to prevent damage
●
●
occurring whilst the ventilation hood is being installed above.
Temporarily mark the height of the bottom of the ventilation hood and the center
●
●
of the cooktop on the wall according to the information given in the 'Installation
instructions — Height of ventilation hood' section.
The wall used for mounting the ventilation hood should have sufficient strength
●
●
and a flat surface.
Attach chimney brackets and ventilation hood mounting screws to the wall
2
Attach the chimney bracket and upper
●
●
chimney bracket (if using the upper
chimney) in the locations shown in Fig.2
(refer to page 13) and Fig.3 (refer to page
14). Use the 1 3/ 1 6" (30 mm) screws (and
expansion plugs if attaching to masonry).
Attach the upper ventilation hood mounting
●
●
screws in the locations shown in Fig.2
(refer to page 13) and Fig.3 (refer to
page 14). Using the 1 3/ 1 6" (30 mm) screws
(and expansion plugs if attaching to
masonry). Ensure that there is a 1/16" (2 mm)
gap between the screw head and the wall (Fig.1).
12
INSTALLATION INSTRUCTIONS
1/ 1 6" (2 mm)
Fig.1
Advertisement
