Table of Contents
Advertisement
*1
When "En-bloc" is selected, you need to press "#" after dialing the phone number.
Note
For details about network parameter settings, refer to the relevant sections of the Hybrid IP-PBX
Feature Guide.
4.1 Programming the PBX in the Los Angeles Office
5.
a.
Double-click CO & Incoming Call.
b.
Double-click CO Line Setting.
c.
Type the CO Name and assign an unused
Trunk Group Number to be used for all VoIP
gateway trunks (CO lines).
d.
Click OK.
6.
a.
Double-click System.
b.
Double-click Numbering Plan.
c.
Double-click Feature.
d.
In the Tie Line Access box, type the dialing
number.
e.
Click OK.
7.
a.
Double-click Private Network.
b.
Double-click TIE Table.
c.
In the Own PBX Code box, type 35 (the PBX
code of the local PBX in the network).
d.
In the Leading Number box, type 41 (the PBX
code of the remote PBX in the network).
e.
In the corresponding Trunk Group list, click the
number of the trunk (CO line) group to be used
when making calls.
f.
Set the number modification pattern, if
necessary.
g.
Click OK.
8.
a.
Double-click Configuration.
b.
Double-click Slot.
c.
Click Status of the card.
d.
Set the status to OUS.
e.
Click Card Type of the card.
f.
In the Value list, click Overlap (default) or En-
*1
bloc
.
g.
Click OK.
h.
Click Status of the card.
i.
Set the status to INS.
Getting Started
43
Advertisement
Table of Contents
