Table of Contents
Advertisement
3.1 Preparations
3.1
Preparations
A web programming utility called the IP-GW16 Maintenance Utility is available for programming of the
VoIP Gateway Card.
For a complete discussion of web programming, refer to the VoIP Gateway Card Programming Guide.
System Requirements
•
The IP-GW16 Maintenance Utility requires Microsoft® Internet Explorer 5.0 or above.
Trademarks
•
Microsoft is either a registered trademark or trademark of Microsoft Corporation in the
United States and/or other countries.
•
All other trademarks identified herein are the property of their respective owners.
•
Screen shots reprinted with permission from Microsoft Corporation.
3.1.1
Preparing the PC
To prepare for programming using the IP-GW16 Maintenance Utility, configure your PC by (1)
assigning an IP address that belongs to the same network as that of the VoIP Gateway Card, and (2)
choosing the appropriate options for the Internet properties.
Note
The procedure below is based on the Windows XP operating system as an example.
22
Getting Started
1. Open Internet Protocol (TCP/IP) Properties from
the Start menu.
2.
a.
Click Use the following IP address.
b.
In the IP address box, type 192.168.1.100.
This is an example entry for the case when the
card has the default IP address
(192.168.1.200).
c.
In the Subnet mask box, type 255.255.255.0.
d.
Click OK.
3.
a.
Start Internet Explorer from the Start menu.
b.
Click Internet Options from the Tools menu.
Advertisement
Table of Contents
