B2
Programming for the Extension Number
Method
When programming the VoIP Gateway Cards and PBXs for use in a network configured for the
extension number method instead of the PBX code method, some of the steps in the programming
procedures require different setting values.
The following 2 sections provide specific steps that require different setting values. The steps other
than those provided here have common setting values, and are therefore omitted from this
explanation.
B2.1
Programming the VoIP Gateway Card
The hunt patterns and address translation table need different setting values for the extension
number method, as shown in the screen shots provided below.
Programming the VoIP Gateway Card in the Los Angeles Office
Create hunt patterns with the setting values shown below, following the procedure in "3.2.4 Assigning
the Hunt Pattern".
B2 Programming for the Extension Number Method
Getting Started
61