Table of Contents
Advertisement
IMI 66-064
(ExecuTech Model 6600S-xx and 6600E-xx Telephones Only)
The optional speakerphone can exercise the
previously described features in a handsfree manner.
Handsfree calling and call answering is as described
below.
To place a call,
•
Press line button or ITCM.
•
Dial number or press programmable button.
•
When party answers, speak toward the telephone.
To answer a call,
•
Press a line button.
AUTODIAL PROGRAMMING
Autodial numbers can be stored at any programmable
button locations that do not have a line assigned to
them. They can also be programmed as a secondary
function at every DSS/BLF memory location. Console
buttons that are fixed for DSS/BLF operation also
provide autodial locations at a second level of storage.
Plus any available buttons between the system station
capacity through a maximum of 32 are available as
autodial locations at the first level of storage.
Typical autodial numbers are: frequently dialed
telephone numbers or extension numbers, or
frequently used host system or key system feature
codes. When programming an autodial number, first
decide over which circuit the call must be made. Then,
determine the digits that normally have to be manually
dialed to reach the called party or feature. This circuit
selection and digit sequence can be stored as an
autodial for later one or two-button access. If line
pre-selection is not programmed, the system will
automatically pick the prime line assigned to the
telephone (if enabled), or pick the last used line at that
station and place the call over that selection.
To program autodial numbers,
•
Press ITCM S S 1.
•
Press desired programmable button. Listen for fast
tone bursts.
•
Press specific line button or ITCM button to store
line or intercom preselection if desired (optional).
SPEAKERPHONE OPERATION
•
To end a call,
•
To switch from speakerphone to handset,
•
To switch from handset to speakerphone,
•
•
STATION USER PROGRAMMING
•
To store another number,
•
•
•
•
•
To store autodial number at DSS programmed
button,
•
•
•
•
•
To end autodial programming,
•
5-8
Speak toward the telephone.
Press SPKR.
Lift handset.
Press SPKR.
Hang up handset.
Dial the number sequence to be stored. (Up to 15
digits can be stored. Valid digits include 0 - 9, #, and
*.)
•
To store a pause if required, press HOLD.
•
To store a hookflash if required, press TAP.
Press TRANS/CONF.
Press next programmable button.
Make line or intercom preselection if desired
(optional).
Dial number for storage.
Repeat this procedure until all desired numbers are
stored.
Press TRANS/CONF.
Press desired DSS button (see page 5-9 for DSS
button programming).
Make line or intercom preselection if desired
(optional).
Dial number for storage
Repeat this procedure until all desired numbers are
stored.
Press MNTR (SPKR).
System Description
Advertisement
Table of Contents
