Stihl FS 45 Instruction Manual page 17

English
4
2
1
3
Mounting the Mowing Head
Keep instruction sheet for mowing
head in a safe place.
Assembling STIHL AutoCut 5-2
: Fit the spring (1) in the head (2).
All other steps are described in the
instruction sheet provided with the
mowing head.
: Wind the nylon lines (3) onto the
spool (4).
: Thread the ends of the nylon lines
through the sleeves and place the
spool in the head.
16
3
6
STIHL AutoCut 5-2
: Push the mowing head (2) over the
shaft (5) and engage the hex recess
(7) on the external hexagon (6).
: Place the cap (8) on the head – turn
it clockwise as far as stop and then
tighten it down firmly.
8
2
7
5
STIHL AutoCut C 5-2
:
:
:
:
8
2
9
Push the mowing head (2) over the
shaft – as with the AutoCut 5-2.
Screw the spool (9) into the head
until the two arrows are in alignment
(see illustration) – secure the spool
in this position.
Push the cap (8) into the spool as
far as stop, turning it clockwise at
the same time.
Turn cap as far as stop and tighten
it down by hand.
FS 45