Protecting The Environment; Rechargeable Battery Pack - DeWalt DCM565 Manual

EnGLIsh

Protecting the Environment

Separate collection. Products and batteries marked
w
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.

Rechargeable Battery Pack

This long-life battery pack must be recharged when it fails to produce
sufficient power on jobs that were easily done before. At the end of
its technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
50
DCM565 TROUBLESHOOTING
Problem Solution
Unit will not start. • Check battery installation.
• Check battery
charging requirements.
• Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down • Charge battery.
in use.
• Unit is being forced. Restart and
apply less pressure.
Battery • Insert battery into charger until red
won't charge. charging light illuminates. Charge up
to 8 hours if battery is totally drained.
• Plug charger into a working outlet.
Refer to Important Charging Notes
for more details.
• Check current at receptacle by
plugging an appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar / • Refer to Adjusting Chain
Tension section.
Chain overheated.
Refer to Chain Oiling section.
•
Refer to Adjusting Chain
Chain is loose. •
Tension section.
Refer to Adjusting Chain
Poor cut quality. •
Tension section. nOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does • Chain could be installed backwards.
not cut. Refer to sections for installing and
removing chain.
Unit does not oil. • Refill oil reservoir.
• Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenance section.