Keyboard-Controller Board; Removing The Keyboard-Controller Board - Dell G15 5530 Owner's Manual

Steps
1. Place the display assembly on the palm-rest and keyboard assembly.
2. Align the screw holes on the display hinges with screw holes on the palm-rest and keyboard assembly.
3. Replace the eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
4. Route the display cable and antenna cables through the routing guides on the palm-rest and keyboard assembly, along the
top side of the computer and into the opening to the right of the power-adapter port.
5. Route the antenna cables further into the rubber on the system board and tabs on the fan.
6. Turn the computer over.
7. Connect the display cable to the connector on the system board and close the latch.
8. Adhere the tape that secures the display-cable connector latch to the system board.
9. Connect the dynamic-display switch (DDS) cable to the system board.
NOTE: This step is applicable only for computers shipped with a 165 Hz or 240 Hz display.
Next steps
1. Install the rear cover.
2. Install the base cover.
3. Follow the procedure in

Keyboard-controller board

Removing the keyboard-controller board

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 59