Table of Contents
Advertisement
USER GUIDE
QUICK START GUIDE
3.
Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
USER GUIDE
reused.
4.
Insert arrow clips into holes.
4.
Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
5.
Remove three screws from hinge holes on the
opposite side. Reinstall into holes where the hinge was
removed. Take care not to scratch cabinet.
Remove bottom hinge:
Remove bottom hinge:
1.
Remove bottom hinge from cabinet using a T-25 TORX
screw driver to remove three screws.
1.
Remove bottom hinge from cabinet using a 1/4"
socket.
2.
Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
nuts if used.
2.
Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
Prepare door for reinstallation:
nuts if used.
1.
Remove outside gasket.
Rotate gasket 180 º and press firmly into the gasket
2.
channel starting at the corners.
3.
Reposition inside gasket.
a.
Before rotating door,
measure distance from
top of outside gasket to
top of inside gasket.
b.
Measure the same
distance up from the
outside edge of the
Door Adjustments
gasket and place a light
mark on each side of
Top of Door
a
Place a mark
on each side
b
Prepare door for reinstallation:
1.
Remove gasket. This will reveal mounting holes for the
magnet assembly.
2.
Remove magnet assembly from door with T-10 TORX
c. Using a flat tool, such as a putty knife, gently pry
driver. Be sure to only remove the two screws holding
off inside gasket.
the assembly to the door. Reinstall on the opposite
end of the door.
d. Rotate door 180
3.
Rotate gasket 180°, aligning notch with magnet
marks on door and firmly press gasket into place.
assembly and pressing firmly into the gasket channel
(If the original adhesive no longer holds the gasket
starting at the corners.
in place, it may be necessary to apply a strip of
two-sided tape.)
4.
Rotate door 180° to reverse.
Install top hinge and door:
Top Hinge
Left Side
1.
Remove pivot screw from hinge, flip hinge over, and
install the pivot screw in the same hole from the
opposite surface.
2.
Lift the door onto the bottom hinge.
3.
Align edge of the hinge with the outer edge of the unit.
4.
Tighten three screws and replace hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT)
Install grille
10
u-line.com
u-line.com
º and
line up top edge of gasket to
Top Hinge
Right Side
Pivot
Screw
Advertisement
Table of Contents
