Table of Contents
Advertisement
Have case Model and Serial Number
ready! This information is located on the
nameplate of the unit.
BEFORE SERVICING
ALWAYS DISCONNECT ELECTRICAL
POWER AT THE MAIN DISCONNECT
WHEN SERVICING OR REPLACING ANY
ELECTRICAL COMPONENT.
This includes (but not limited to) Fans, Heaters
Thermostats, and Lights.
CAUTION
Fluorescent Lamp Disposal:
The United States Environmental protection Agency has
information regarding environmentaly-safe fluorescent
lamp waste management programs. On the Net: EPA
Web site.
http://www.epa.gov/osw/hazard/wastetypes/universal/
lamps/recycle.htm
Replacing Fluorescent Lamps
Fluorescent lamps are furnished with a shatterproof
protective coating. The same type of lamp with protective
coating must be used if replaced.
10. Maintenance
Evaporator Fans
The evaporator fans are located at the center front of these
merchandisers directly beneath the display pans. Should
fans or blades need servicing, always replace fan blades
with the raised embossed side of the blade TOWARD THE
MOTOR.
Copper Coils
The copper coils used in Hussmann merchandisers may
be repaired in the field. Materials are available from local
refrigeration wholesalers.
Hussmann recommends using #15 Sil-Fos for repairs.
Tips and Troubleshooting
Before calling for service, check the following:
1. Check electrical power supply to the equipment for
connection.
2. Check fixture loading. Overstocking case will affect
its proper operation.
3. If frost is collecting on fixture and/or product, check
that Humidity Control is working properly, and that
no outside doors or windows are open - allowing
moisture to enter store.
When cleaning:
Do not use high pressure water hoses
Do not introduce water faster then waste outlet can drain
NEVER INTRODUCE WATER ON SELF CONTAINED UNIT
NEVER USE A CLEANING OR SANITIZING SOLUTION
TO PRESERVE THE ATTRACTIVE FINISH:
DO USE WATER AND A MILD DETERGENT FOR THE
DO NOT USE A CHLORINATED CLEANER ON ANY
DO NOT USE ABRASIVES OR STEEL WOOL SCOURING
13
ENCAPSULITE
SHATTERPROOFCOATING- SA10645
Complies w i t h FDA USDA
R
& OSHA R e g u l a t i o n s
for replacement call:
1-800-395-9229
Turn switch off then on after replacing bulb
CAUTION
CLEANING PRECAUTIONS
WITH AN EVPORATOR PAN
THAT HAS AN OIL BASE (these will dissolve the butyl
sealants) or an AMMONA BASE (this will corrode the
copper components of the case)
EXTERIOR ONLY
SURFACE
PADS (these will mar the finish)
N S F
Advertisement
Table of Contents
