Channel; Channel1, 2 (Ch1, 2) - Boss Gigcaster 5 Parameter Manual

CHANNEL

CHANNEL1, 2 (CH1, 2)

INPUT
Parameter Value
(Bold: default)
Selects the input source.
GTR
CH1, 2
INPUT
1&2
HEAD SET
OFF
INPUT: GTR, HEAD SET
GAIN
-20–0–+20 dB
INPUT: CH1–2, 1&2
GAIN -20–0–+70 dB
+48V OFF, ON
EQ
Parameter Value
(Bold: default)
OFF, ON
(ON/OFF)
LOW
-20–0–+20 dB
LOW MID
-20–0–+20 dB
FREQ
20.0–500
Q
0.5–1–16
HIGH MID
-20–0–+20 dB
FREQ 20.0–500
Q 0.5–1–16
HIGH
-20–0–+20 dB
LOW CUT
FLAT, 20.0–80
HIGH CUT 20.0 Hz–16.0 kHz,
PAN
L50–CENTER–R50
Explanation
Guitar connected to the Guitar jack
* Only for channel 1
Mic or audio equipment connected to the MIC 1, 2 connectors
Select these when you want to use channels 1/2 as a stereo link.
When stereo link is turned on, the same settings apply to both channels.
* Turning on stereo link also automatically turns one of the channels off.
Headset mic
* You can set "HEAD SET" for just one channel.
Off (no used)
Adjusts the input gain.
Adjusts the input gain.
Turns the phantom power on/off.
* Always turn the phantom power "OFF" when connecting any device other than condenser
microphones that require phantom power.
Explanation
Turns EQ on/off.
Adjusts the gain for the low frequency range.
Adjusts the gain for the low-middle frequency range.
Hz–16.0 kHz
Specifies the center of the frequency range that will be adjusted by the LO MID.
Adjusts the width of the area affected by the EQ centered at the LO MID FREQ.
Higher values will narrow the area.
Adjusts the gain for the high-middle frequency range.
Hz–16.0 kHz Specifies the center of the frequency range that will be adjusted by the HI MID.
Adjusts the width of the area affected by the EQ centered at the HI MID FREQ.
Higher values will narrow the area.
Adjusts the gain for the high frequency range.
Specifies the frequency at which the low cut filter begins to take effect.
Hz–16.0 kHz
When "FLAT" is selected, the low cut filter will have no effect.
Specifies the frequency at which the high cut filter begins to take effect.
FLAT
When "FLAT" is selected, the high cut filter will have no effect.
Sets the stereo location (pan) of the sound.
3