Case CX Series Service Training Manual page 89

RST
1
BRK
L/M
AI
Push the Buzzer stop switch to select BRK (item selected will have a light
background).
To set engine speed for hammer mode, start the engine and adjust RPM
with the throttle control. Monitor will show actual RPM. Press the Work
mode switch for 10 seconds to select the displayed RPM. The buzzer will
sound to notify that 10 seconds have elapsed.
Start the engine and adjust engine speed to desired RPM using the Free
Swing switch to increase RPM and the Cushion switch to decrease RPM.
The switches must be held for 5 seconds for a RPM change to occur.
Press and hold the work mode switch for 10 seconds. The alarm buzzer will
sound.
Turn the key switch off while running at desired RPM to complete the
procedure. To confirm, start the engine, turn up the RPM, access CHK1
and observe the RPM when the hammer circuit is activated.
CONTROLLER
RESETTING
Engine Speed for Hammer Mode
MODE Hi, H
0 0 0 0
Not Used
0 0 0 0
CX130/CX160
CX210/CX240
PA
RPM AU
RPM HLD
SEC OUT
3 - 49
0 0 0 0
0 0 0 0
0 0 0 0
Not Used
CX EXCAVATORS