Panasonic AJ-D455 Operating Instructions Manual page 34

Setup menus
USER menu
<VIDEO>
No.
612
613
620
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
WIDE 0000
SELECT 0001
0002 NORMAL
VIN SETUP 0000
0001
Pb/Pr OUT 0000
LV 0001
AUTO This selects the operation to be conducted in response to the
WIDE information.
WIDE
0: During recording, if the S1-VIDEO input signals contain
WIDE information, the WIDE information is recorded on the
tape.
During playback, if WIDE information is on the tape, it is
added to the S1-VIDEO output signals.
1: During recording, the WIDE information is recorded on the
tape regardless of whether the S1-VIDEO input signals
contain the WIDE information.
During playback, the WIDE information is added to the S1-
VIDEO output signals regardless of whether the WIDE
information is on the tape.
2: During recording, the WIDE information is not recorded on
the tape regardless of whether the S1-VIDEO input signals
contain the WIDE information.
During playback, the WIDE information is not added to the
S1-VIDEO output signals regardless of whether the WIDE
information is on the tape.
<Note>
This item is effective during recording at the start of the
recording and during playback at all times. Therefore, when its
setting has been changed during recording, the MENU
contents will be changed but no change will occur in the actual
operation.
THRU This selects whether the composite signal is to be recorded
with setup or without setup.
CUT
0: When recording signals with no setup.
1: When recording signals with 7.5% setup.
<Note>
When recording composite signals, be sure to double-check
whether the signals are to be recorded with or without setup.
M II For selecting the analog component output level.
0: M II level
B-CAM
1: Betacam level
34
Description
Forced WIDE ON
Forced WIDE OFF