Table of Contents
Advertisement
Note: The instruction of calibrating the aimer in vertical centering direction.
1.
Scan the barcode ("%initD00%") on this page. The embedded scanner will give three musical short
beeps to indicate entering calibration mode.
2.
Press the trigger of the embedded scanner while maintaining the distance of about 15cm between
the exit window of the embedded scanner and this paper. After a few seconds, the embedded
scanner will give three short beeps to indicate a successful calibration, or a long beep to indicate a
failed calibration.
3.
If the calibration is failed in step 2, please repeat the steps 1-2. If it is not succeed after a multiple
times of calibration, please contact your local dealer or the manufacturer for further instruction.
35
Advertisement
Table of Contents
