Panasonic WJ-RT416 Installation Manual page 65

I Baud Rate
Select the communication speed for data transmission
with a connected device from the following.
2 400/4 800/9 600/19 200/38 400 bps
Default: 9 600
I Data Bit
The data bit will be displayed. It is impossible to
change the value for this setting.
8 (bit)
I Parity
Select a method to check a transmission error at com-
munication from the following.
None: No parity check
Even: Even parity
Odd: Odd parity
Default: None
I Stop Bit
Select a stop bit from the following.
1 bit/2 bit
Default: 1 (bit)
I Retry Timing
Select a retransmission interval for when data reception
is not confirmed from the following.
Off/100 ms/200 ms/400 ms/1 000 ms
Default: Off
I Alarm Data
Select a method to inform the connected controller of
an event occurrence from the following.
Off: Does not function.
0s: Informs the controller every time an event is detect-
ed.
1s/5s: Informs the controller when a specified time has
passed after detecting an event.
Default: 1 s
I Camera Number Setup
It is possible to assign a number to each camera chan-
nel to operate cameras using the controller compatible
with PS·Data.
Do the following to assign numbers to the camera chan-
nels.
(1) Move the cursor onto "Set" next to "Channel No."
and press the [SET] button.
The "Channel No." menu will be displayed.
Camera Number Setup
Port Cam Port
1 001 2
3 003 4
5 005 6
7 007 8
9 009 10
11 011 12
13 013 14
15 015 16
OK
(2) Assign a camera number (to be operated using the
controller) for each camera port using the camera
selection buttons.
(3) After completing the camera number assignment,
move the cursor onto [OK] and press the [SET] but-
ton.
Cam
002
004
006
008
010
012
014
016
Cancel
65