Extron electronics DTP3 T 202 Setup Manual page 2

DTP3 T 202/DTP3 R 201 • Setup Guide (Continued)
NOTE:
One power supply is included with the transmitter and normally can power both units, if they are both from the
Extron DTP3 series.
Smooth
Ridges
SECTION A–A
Figure 3. Power Wiring Diagram
B Loop Out port (Tx) — Connect a display with an HDMI input to display the Input signal to the transmitter.
C HDMI Input (Tx) — Connect an HDMI cable between this port and the digital video source.
NOTE:
See the
D DTP RJ‑45 ports — Connect transmitter Out to receiver DTP3 In, using a twisted pair cable.
Extron recommends terminating both cable ends in accordance with the wiring specifications
in the diagram on the right, at a minimum:
• TIA/EIA T 568 B
ATTENTION:
• Do not connect these devices to a telecommunications or computer data network.
• Ne connectez pas ces appareils à un réseau de télécommunications ou de données
informatiques.
E
RS‑232 ports — To pass serial, infrared data, or control signals, connect the master device to the
transmitter and the slave device to the receiver via the RS‑232 captive screw connectors on
both units (see figure 4 for wiring).
RS-232 Device Bidirectional
Transmit (Tx) Transmit (Tx)
Receive (Rx) Receive (Rx)
Ground(Gnd) Ground(Gnd)
Figure 4. RS‑232 Wiring Diagram
F HDMI Output (Rx) — Connect a display with an HDMI input to view the transmitted digital image.
G Audio Output (Rx) — Connect a balanced or unbalanced audio device, such as an audio amplifier or powered speakers, to
the receiver via the audio captive screw connector (see figure 5 to wire analog audio output).
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
Figure 5. Balanced and Unbalanced Audio Output Wiring Diagram
ATTENTION:
• For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (–)
contacts.
• Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS connecter les manchons aux
contacts négatifs (–).
2
POWER
A
12V
3/16"
A
(5 mm) Max.
LockIt™ Lacing Brackets on the next page to securely fasten HDMI connectors.
• CAT 6A, shielded
RS-232
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
--A MAX
• 22 AWG, solid conductor
Do not tin
the wires!
Pins:
TIA/EIA T
12345678
568 B
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
TP Wires