Advertisement
STEP 4 (See Diagram 4 & Cable Loop Diagram)
A.) Attach the 124" Upper Cable (#50) to the opening at the front of the Upper
Frame (#10). Note: The Ball Stopper on the cable should be underneath the
Frame.
B.) Attach a Pulley (#47) to the opening. Secure it with one M10 x 1 ¾" Allen Bolt
(#86), two Ø ¾" Washers (#95), and one M10 Aircraft Nut (#92).
C.) Draw the Cable towards the back of the machine to the open bracket on the
Upper Vertical Frame (#7). Repeat Procedure B above to install a Pulley to the
bracket.
D.) Draw the Cable around the Pulley then pull back towards the opening on the
Front Press Base (#11).
E.) Attach a Pulley to the opening on the Front Press Base. Secure the Pulley with
one M10 x 5 3/8" Allen Bolt (#82), two Ø ¾" Washers (#95), and one M10
Aircraft Nut (#92).
F.) Draw the Cable around the Pulley then through the opening on the Upper
Vertical Frame to the open bracket on the back of Upper Vertical Frame. Repeat
Procedure B above to install another Pulley to the bracket. Draw the Cable
around the Pulley then downward.
G.) Open the two plastic Pulley Covers (#49) on a Small Pulley (#48). Draw the
Cable around the Small Pulley then reinstall the two Covers. Attach the Small
Pulley to two Double Floating Pulley Brackets (#22).
H.) Secure the Small Pulley to the two Double Floating Pulley Brackets (#22) with
one M10 x 2 1/8" Allen Bolt (#85), two Ø ¾" Washers (#95), and one M10
Aircraft Nut (#92). Let the bracket hanging for now.
I.)
Pull the Cable upward to the open bracket underneath the Upper Frame. Install a
Pulley to the bracket.
J.)
Pull the Cable downward between the two Guide Rods to the Selector Rod
(#23). Fully thread the bolt at the end of the Cable into the top opening on the
Selector Rod.
K.) Connect the Lat Bar (#24) to a Short Chain (#30) with a C-clip (#32). Then
connect the Short Chain to the Upper Cable with another C-clip.
14
Advertisement
