Pokyny Na Použitie - Orca 40 CL Operating And Maintenance Instructions Manual

A, B, C are printed on the groove of the wheel limit pile of the chassis. Wheel limit piles will be
installed by default on C (left) and A (right).
Wheel buckle
Úchyt kolieska
Wheel limit pile
Zarážka kolieska
As shown in the figure, push the wheel buckle, pull down the wheel components, and remove them.
Potom znova do podvozku nainštalujte zarážku za účelom vymedzenia rôznych dráh.
ODPORÚČAJÚ SA ŠTYRI POLOHY NASTAVENIA KOLIESOK:
Setting 2: C-A, when the turning angle is too large
1. nastavenie: predvolené nastavenie: C-A, pre väčšinu bazénov
Wheel
Uhol kolieska
Angle
Dráha
Running
path
POKYNY NA POUŽITIE UTILISATION
Zatlačte na úchyt kolieska, ako je znázornené na
Then re-install the limit pile into chassis to realize the different running paths. obrázku, stiahnite komponenty kolieska a vyberte ich.
b. Four settings for wheels are recommended:
Setting 1: default setting: B-C, for most of pools
Wheel Angle
Setting 2: C-A, when the turning angle is too large
Wheel
Angle
Running
Running path
path
7
170