Table of Contents
Advertisement
User´s manual
MP DRY CABINET II
2
Safety at Work, Fire Protection
2.1
Obligations of the Operator
°
The operator shall be obliged to secure the compliance with generally binding safety regulations during the work
with the device.
°
The operator shall be obliged to perform visual checks of the device and the basic maintenance.
°
The operator shall be obliged to determine responsibilities of persons for the commissioning, maintenance,
cleaning and regular maintenance, setting and adjusting before the commissioning in order to secure the safety of
persons and property.
°
The operator shall be obliged to provide that the relevant activities are performed by persons with adequate
qualification.
°
The operator shall be obliged to provide safe access to the device and sufficient space for the access to the
device.
°
The operator shall be obliged to renew the state of the safety markings upon their damage or illegibility in
accordance with their original state.
2.2 Qualification Requirements on Employees
°
The device assembly may only be performed by an expert acquainted with the operation, safety and other
regulations, if any, concerning the safety at work, valid for the place in which the device is to be located or
otherwise related to the place of work.
°
The assembly and wiring of the electrical configuration of the device shall only be performed by an employee
with qualification complying with the valid legislation of the country in which the device is operated.
°
The device may only be operated independently by employees with full physical and mental capacity, older than
18, demonstrably trained for the given type of work and acquainted with the Service Instructions which shall be
kept in a well-accessible place.
2.3
Conditions of Safe Operation of Electric Devices
°
The User´s manual shall be available to all staff performing activities related to the installation, operation and
maintenance of the electric device, at any time.
°
The installation, operation and maintenance shall only be provided by persons qualified for these activities in
accordance with valid legislation of the country in which the device is operated.
°
It is PROHIBITED to interfere in any way with the construction of the device.
°
It is PROHIBITED to perform maintenance, cleaning and repairs if the electric supply is not disconnected and
if the related technological equipment is not secured to be off.
°
It is PROHIBITED to have the device work with open or removed covers – blanking plates.
°
It is PROHIBITED to touch the inner sheathing of the device and the inner side of the door while the heat may
cause burns.
2.4
Fire Protection
•
The device and its operation do not increase the fire hazard.
•
ATTENTION, an electric device, do not extinguish with water or foam.
2.5
Safety Labels Used and Their Significance
Do not extinguish with water or foam!
page 4/22
Advertisement
Table of Contents
