Maintenance; Empty The Dust Cup; Cleaning Filters; Replacement Filters - Shark Stratos DuoClean HZ3000UK Series Instructions Manual

MAINTENANCE

IMPORTANT: Unplug the vacuum before performing any maintenance.
EMPTYING THE DUST CUP
Empty the dust cup each time you vacuum and periodically during cleaning, when debris in the dust cup
reaches the MAX fill line.
Press the Wand Release button and lift off
the handheld vacuum.
(Click)
Hold the dust cup over the bin. Press the yellow
Empty button and pull open the dust cup lid until
it clicks and locks in the open position. Gently tap
the cone-shaped screen inside the dust cup to
knock dust and debris into the bin.
14
sharkclean.co.uk
To remove the dust cup from the handheld
vacuum, press the two Dust Cup Release
buttons at the same time and pull out the
dust cup from the top.
To reinstall, push the lid closed, then insert
the dust cup into the handheld vacuum from
the top, until it clicks into place.
MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.

CLEANING FILTERS

Regularly rinse and replace the filters to maintain your vacuum's suction power and to maximise the
effectiveness of the Anti-Odour Technology.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
PRE-MOTOR FILTERS
The Pre-Motor Filters should be rinsed every month. To remove
the pre-motor filters, detach the dust cup, then slide down the
Filter Access buttons on both sides of the dust cup lid. Pull out
the filter housing, then lift out the Felt Filter by the pull tab. Next,
remove the Foam Filter. After the filters have been rinsed and are
completely dry, insert the foam filter into the housing first, then
slide in the felt filter, and reinstall the housing into the dust cup lid.
HEPA FILTER
The HEPA Filter should be rinsed every 6
months. To remove the HEPA filter, detach
the dust cup, then pull the Filter Release
tab on the handheld vacuum filter cover.
Remove the cover, then squeeze the side
tabs on the HEPA filter and lift it out. After
the filter has been rinsed and is completely
dry, reinsert it into the handheld vacuum,
then reattach the filter cover.

REPLACEMENT FILTERS

NOTE: For replacement filters please visit sharkclean.co.uk
NOTE: The pre-motor filters should be
replaced every 2.5 years. The post-
motor filter should be replaced every
3 years.
sharkclean.co.uk
15