Traditional Method For Framed And Frameless Cabinets; Operating Instructions; Powering On/Off The Unit - Vissani 1803B/HP11(75) Use And Care Manual

Installation(continued)

TRADITIONAL METHOD FOR FRAMED AND FRAMELESS CABINETS

NOTE:
Hardware not provided for this assembly option. Consult with your professional installation specialist for what type of
fasteners should be used for your cabinet construction.
1. If cabinets have face frames with a recessed bottom, attach 2-3" wide wood filler strips to the underside of the cabinet
bottom on each side. Be sure the width of the filler strip does not cover the power cord hole.
a) If you wish to use wider filler strips you will need to cut a hole in the filler strip to accommodate the power cord.
b) Secure filler strips to bottom of cabinet using screws (not supplied). The range hood will attach to the filler strips.
c) If you are not using filler strips due to your cabinet not having a face frame, you may choose to use shorter screws
based on the depth of your cabinet bottom.
2. Determining the fastener locations.
a) Temporarily remove the 3-1/4"X 10" rectangular or 7" round duct vent on top or back of range hood.
b) Temporarily position the range hood in the desired mounting location under the cabinet (this will require 2 people).
Mark the mounting holes with a pencil or marker at the center of the 4 mounting keyholes. You will mark the
holes from underneath the range hood to the bottom of the cabinet. Leave a small gap between the range hood and
the wall.
3. After mounting holes have been marked, reassemble the 3-1/4"X 10" rectangular or 7" round duct vent to the range hood.
4. Drill a starter pilot hole (make sure starter hole is not larger than the diameter of the screw) into the bottom of the cabinet
for each of the mounting hole marks created in the step 2 b)in P 15.
5. Insert four screws (not supplied) into the holes marked in the step 2 b)in P 15. Do not screw all the way in. Leave a ¼" or
more space.
Space
6. Lift the range hood (2 people) and position so that the large opening of the mounting keyholes are over the screws. Please
ensure you push the electrical cord through the bottom of the cabinet. Push the range hood up and gently towards the wall.
Filler Strips
Mark at center of mounting keyhole
16
Installation(continued)
The range hood should lock into the narrow portion of the keyholes and be secure for final installation.
7. From underneath range hood finish tightening the screws from step 5. Use a level to ensure the range hood is balanced as
you tighten screws.

Operating Instructions

NOTE:
There are different operating instructions based on the control panel for your model. Please choose the operating
instruction for your unit.

POWERING ON/OFF THE UNIT

1
Ÿ To turn the fan on push a button to select one of the 3 speeds:
ž 2=High
ž 3=Medium
ž
4=Low
If you choose a new speed by pressing a different button, the new fan speed will replace the old fan speed.
Ÿ To turn fan off push button 5.
Ÿ To operate light on/off push button 1(Note: The fan and light operate independently of each other).
2 3 4 5
17
Please contact 1-855-847-7264 for further assistance.
HOMEDEPOT.COM