For Frameless Cabinets; Electrical - Vissani 1803B/HP11(75) Use And Care Manual

Installation(continued)

FOR FRAMELESS CABINETS

1. Install the two easy installation brackets (H) to each side of the cabinet as shown below using the #8 X 5/8" screws (AA)
(cabinet constructions will differ, ensure the length of the screw is appropriate for your cabinet construction).
H
Frameless Bracket
CC
2. The easy installation brackets (H) under the cabinet on each side. The brackets will be labeled Front (F) Back (B). Insert
and screw in the (3) #8 X 5/8" screws (AA) as shown below. You may choose to drill a starter hole.
3. Same as step 2 for framed cabinet.
4. For final securing of the range hood to the bottom of the cabinet, screw in (4) of the #8 X 1/2" wood screws (CC) to each of
the easy installation brackets to bottom of cabinet as shown below.
CC
5. (Optional) You may wish to additionally secure the range hood by screwing in (2) #8 X 1/2" wood screws (CC) into the access
hole as shown below to the bottom of the cabinet.
Bottom View
Front of Range Hood
AA
Flush to Back and Side
AA
14
Installation(continued)

ELECTRICAL

If your unit is hard-wired, make sure this is done by a qualified electrician in accordance with all national and local electrical
codes.
a) Before connecting the wires, switch the power off at the service panel and lock the service panel to prevent power
from being switched on accidentally.
b) Connect the Black to Live, White to Neutral, and Green to Ground by either a solder or with electrical connectors.
c) This unit must be properly grounded.
NOTE: Use either the top hole(pic3)or the back hold(pic 2) of the range hood depending on your installation type.
If you need to use the back hold, please follow up below step 1~step 4.
STEP1: Remove the filters of the range hood to find the power cable case (pic 1).
pic 1
STEP2: Use the screwdriver to remove the cover of the power cable case.Use a flexible,armored,or nonmetallic sheathed
copper cable only. (You can use the rubber coil to stable the power cord-C)-(pic 2)
*Never use an extension cord or adapter plug.
2
pic 2
STEP3: Use the screwdriver to remove the cover of the power cable case.Use a flexible,armored,or nonmetallic sheathed
copper cable only. Never use an extension cord or adapter plug
STEP4: Remove the screws on the top of the rangehood -(pic 3)
1
C
pic 3
15 HOMEDEPOT.COM
Please contact 1-855-847-7264 for further assistance.