Component & Control Location; Features; Checks - Honda GX630 Owner's Manual

37ZCK803.fm 3 ページ ２０２１年７月２日 金曜日 午後２時２２分
COMPONENT & CONTROL LOCATION
SPARK PLUG
OIL FILTER
OIL DRAIN BOLT
OIL LEVEL DIPSTICK MUFFLER (B type OPTIONAL EQUIPMENT)
OIL FILLER CAP
SPARK PLUG
OIL DRAIN BOLT
ELECTRIC STARTER

FEATURES

Oil Alert® System (applicable types)
''Oil Alert is a registered trademark in the United States''
The Oil Alert system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the
crankcase can fall below a safe limit, the Oil Alert system will automatically
stop the engine (the engine switch will remain in the ON position).
If the engine stops and will not restart, check the engine oil level (see page
6) before troubleshooting in other areas.
Fuel System
This engine uses LPG or NATURAL GAS and requires a fuel regulator and
related parts that are not included with the engine. Proper installation and
maintenance of these parts should be performed by your servicing dealer.
BEFORE OPERATION CHECKS
IS YOUR ENGINE READY TO GO?
AIR CLEANER
For your safety, to ensure compliance with environmental regulations, and
to maximize the service life of your equipment, it is very important to take a
PROTECTOR FAN
few moments before you operate the engine to check its condition. Be sure
COVER
to take care of any problem you find, or have your servicing dealer correct
it, before you operate the engine.
Failure to properly maintain this engine, or failing to correct
a problem before operation, could result in a significant
malfunction.
Some malfunctions can cause serious injuries or death.
Always perform a pre-operation inspection before each
operation, and correct any problem.
Before beginning your pre-operation checks, be sure the engine is level and
the engine switch is in the OFF position.
Always check the following items before you start the engine:
Check the General Condition of the Engine
1. Look around and underneath the engine for signs of oil leaks.
2. Remove any excessive dirt or debris, especially around the muffler and
fan cover.
3. Look for signs of damage.
4. Check that all shields and covers are in place, and all nuts, bolts, and
screws are tightened.
MUFFLER (A type
Check the Engine
OPTIONAL EQUIPMENT)
1. Check the engine oil level (see page 6). Running the engine with a low
oil level can cause engine damage.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below safe limits. However, to avoid the
inconvenience of an unexpected shutdown, always check the engine
oil level before startup.
2. Check the air filter element (see page 7). A dirty air filter element will
restrict air flow to the carburetor, reducing engine performance.
3. Check the equipment powered by this engine.
Review the instructions provided with the equipment powered by this
engine for any precautions and procedures that should be followed
before engine startup.
ENGLISH
3