Unexpected Problems; Transporting - Honda GX630 Owner's Manual

37ZCK803.fm 10 ページ ２０２１年７月２日 金曜日 午後２時２２分
Storage Precautions
Select a well ventilated storage area away from any appliance that operates
with a flame, such as a furnace, water heater, or clothes dryer. Also avoid
any area with a spark-producing electric motor, or where power tools are
operated.
If possible, avoid storage areas with high humidity, because that promotes
rust and corrosion.
Keep the engine level in storage. Tilting can cause oil leakage.
With the engine and exhaust system cool, cover the engine to keep out
dust. A hot engine and exhaust system can ignite or melt some materials.
Do not use sheet plastic as a dust cover.
A nonporous cover will trap moisture around the engine, promoting rust
and corrosion.
If installed, remove the battery and store it in a cool, dry place. Recharge the
battery once a month while the engine is in storage. This will help to extend
the service life of the battery.
Removal from Storage
Check your engine as described in the BEFORE OPERATION CHECKS section
of this manual (see page 3).
If the cylinders were coated with oil during storage preparation, the engine
may smoke briefly at startup. This is normal.

TRANSPORTING

If the engine has been running, allow it to cool for at least 15 minutes
before loading the engine-powered equipment on the transport vehicle. A
hot engine and exhaust system can burn you and can ignite some
materials.
Before you can transport or store the engine, the LPG or NATURAL GAS
supply line must be disconnected. A qualified LPG or NATURAL GAS
technician must do this. Consult a local LPG or NATURAL GAS supplier or
your servicing dealer.
10
TAKING CARE OF UNEXPECTED PROBLEMS
ENGINE WILL NOT START
Possible Cause
Battery discharged.
Fuse burnt out.
Fuel valve CLOSED or OFF.
(If equipped)
Engine switch OFF.
Engine oil level low (Oil Alert
stops engine).
Out of fuel.
Spark plugs faulty, fouled, or
improperly gapped.
Carburetor malfunction, ignition
malfunction, valves stuck, etc.
ENGINE LACKS POWER
Possible Cause
Filter element(s) restricted.
Fuel quality or pressure is poor.
Carburetor malfunction, ignition
malfunction, valves stuck, etc.
ENGLISH
Correction
Recharge battery.
Replace fuse.
Move lever to OPEN or ON position.
Turn engine switch to ON position.
Fill with the recommended oil to
the proper level (p. 6).
Refuel (p. 5).
Gap, or replace spark plugs (p. 8).
Take engine to your servicing
dealer, or refer to shop manual.
Correction
Clean or replace filter element(s) (p.
7).
Use a reliable LPG or NATURAL gas
source.
Take engine to your servicing
dealer, or refer to shop manual.